The work of the fence is to determine the location of the anchor hole. According to the design of the bolt spacing requirements, generally to the foot side of the foot as a base point, and gradually to the other side and the top of the determination of the location of the bolt.

Fence mesh into the hole, the general use of light hand-held drilling machine drilling holes. Drilling operations generally should be carried out from top to bottom in the order of construction, in the process can not completely clear the impact of the construction of safe slope floating soil, pumice to be cleared again. Generally should be in the drilling or drilling at the same time, at the hole chisel a design to meet the requirements of the pit, its main role is to pass through the location of the anchor ring exposed rope can be attached to the slope, so , The size of the anchor can be exposed to the top of the inner ring is not higher than the hole on the ground can be.

Bolt installation, wire rope bolt installation and ordinary reinforced mortar anchor similar to ensure that the mortar and the hole wall of the good bond and the grip of the anchor, the same need to wash holes and rod alignment. Due to the flexibility and flatness of the wire rope anchor, the depth of the anchorage can be easily achieved by manually stirring the rod body to make the slurry in the hole evenly and even when the depth of anchorage is larger. Pulp.

Support rope installation is relatively simple, will be a certain length of the rope through one end of the outer ring of the exposed ring and fixed with a rope card, one by one through the same row or with the same row of anchor rods, until the end of the support rope bolt , With the tension capacity of not less than 10kN tight line or gourd tension support rope, with the same specifications of the rope card will be fixed to complete the end. From the construction safety and reduce the workload of cutting considerations, the laying of the grille should generally be carried out from top to bottom, the network should be overlapping between one to two rows of mesh width and tie together, should make the network as flat as possible and close to the slope surface.